Will this work and will the sound quality be good? Is this the best approach? A little concerned about using RCA splitter cables. I would then need to configure Visual Pinball and FX3 following Major Frenchy's guide. This amp will then connect to the rear mounted exciters.Ĭonfigure the PC to output sound from both Onboard Sound Device and HDMI. Connect the other 2.1 channel amp to the PC side channel via mini jack to RCA cable. This amp will then connect to the front mounted exciters. Separately connect a 2.1 channel amps to the PC rear channel via mini jack to RCA cable. Connect the 1 channel sub amp speaker outputs to the subwoofer. ![]() Connect the 2channel amp speaker outputs to the 4in and 2in speakers in series, both left and right. Use RCA splitter cables connecting the LOC to the 2 channel amp and 1 channel sub amp. I will be installing the sub into the middle of the cabinet with the exciters located two to the front and two to the back.Ĭonnect the speaker R & L out from the circuit board into a 2 channel line-output converter. I built a new backbox to house the pair of 4in speakers and 2in speakers. When you connect the ALP to a PC via HDMI, the sound is delivered from the PC thru the HDMI which is connected back to the main circuit board and outputs to the two speakers. The two ALP speakers are connected directly to the main circuit board, which must have an integrated amplifier. The ALP came equipped with a pair of 2in. ![]() 4ohm full speakers, 4 exciters, and an additional two 2.1 amps. I have purchased a 2 channel amplifier, a 1 channel sub amplifier, an 8in. ![]() I would like to achieve better sound from both the ALPs built in tables and when connected to a PC. Looking for some advice on how to connect amplified speakers to the Atgames Legends Pinball cabinet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |